Shindaiwa DG250MI Portable Generator User Manual


 
- 36 -
10.1 Oil Change
First time 50 hour mark
From second time Every 200 hours
Remove Oil Filler cap
Loosen the engine oil drain plug and allow the oil
to drain fully
Reinstall the drain plug
Add oil from oil filler and fill up to the MAX level.
You should check the oil level on the dipstick
Reinstall the filler cap hand-tight
<Caution>
For the types of engine oil to use and volume to replace, refer to <8-1 Checking Engine Oil>
10.2 Oil Filter Change
First time 50 hour mark
From second time Every 400 hours
Drain the engine oil fully, as described in 10.1
Loosen and remove the oil filter, using an oil filter wrench
Smear a little engine oil on the rubber gasket of the new oil filter
Screw the new filter into place and tighten it by hand until the
gasket contacts the seat. Then, give it additional 2/3 turn to seat
the filter, using an oil filter wrench
Add oil and install filler cap
<Caution>
If an oil filter wrench is not available, contact our authorized
distributor or our engineering section..
Oil filter:
Model ISUZU Part No.
DG150MI 8944567412
DG250MI 8944567411