Filter
Top Products
- 27 -
8.2.3 Coolant Capacity
(Unit : L)
Total Coolant Volume
(including reservoir tank)
DG150MI 7.4 (0.4)
DG250MI 8.5 (0.4)
Value in ( ) shows the reservoir tank’s volume
8.3 Checking Fan Belt
Also refer to the user’s manual for Engine separately
!
Danger
:Injuries
Before performing any equipment check or maintenance, stop the engine, and remove the engine
key. A person performing the maintenance should always keep the key.
Close all doors and place locks during operating this equipment, to avoid injuries by unintentionally
touching cooling fan and fan belt.
!
Caution
:Burns
Do not touch the engine and muffler during operation and immediately after stopping the equipment,
for the temperature can reach extremely high.
8.3.1 Tension
Tension should be optimum when the fan belt has 8 to 12mm
slacks, when applying finger pressure (about 98N{approximately
10kgf}) at midpoint between fan pulley and alternator pulley.
8.3.2 Condition
Check for any damage on the fan belt. Replace if necessary.
<Caution>
Refer to the <User’s manual for Engine> for adjusting and replacing of the fan belt.