Filter
Top Products
ASSEMBLY
2160 07/11 Assembly Section 3-4
© 2011 Alamo Group Inc.
ASSEMBLY
MOWER TO TRACTOR ATTACHMENT
This mower is designed for 540 or 1000 RPM PTO with CAT II or CAT III Quick Hitch (Standard) or CAT II or
CAT III 3-Point Hitch (Optional).
CAT II and III Quick Hitch ( Standard) (Asm-B-0031)
Back-up tractor with Quick Hitch and align bottom lugs (1) of hitch to lower lugs (2) of frame. Then raise lift
arms until Pins (3) lock into lower lugs (1). Top lug (4) on Quick Hitch should simultaneously hitch to Pin (5) on
top of Rhino Boom Frame.
CAT II and III 3-Point Hitch (Optional Equipment)
Attach the lower hitch arms to the lower lugs of the frame and attach the top link to the tractor. The Hydraulic
Relief Arm (Optional Equipment) is required for attaching the 2160 to a tractor not equipped with a quick hitch.
When using this type of hitch it should be the last thing assembled. Instructions for this hitch will be later in this
section (pages 3-12).
NOTE: Once unit is attached to the tractor be sure to remove the shipping pallet.