Filter
Top Products
ASSEMBLY
1598 01/11 Assembly Section 3-13
© 2011 Alamo Group Inc.
ASSEMBLY
5. On level ground, tilt the attachment down 90 degrees
and lower it to the ground. Lower the loader further to
slightly raise the front of the tractor of the tractor off
the ground. Drive the tractor in reverse while the
attachment is on the ground for 20-30 feet to insure
the attachment does not disconnect. If the
attachment disconnects during this process,
discontinue the use of attachment and contact your
dealer.
Pre-Operation Check
1. Adjust front wheel tread setting stops, if necessary, to provide a minimum 3/4” clearance between front
tires and any part of loader with lift cylinders fully oscillated. Be sure lift cylinders are fully retracted. Refer
to page 3-5, under Preparing the Tractor. Refer to Tractor Operator’s Manual for tread setting and
steering stop adjustment procedures.
2. Lubricate all grease fittings with SAE multi-purpose grease.
3. Check hydraulic fluid level in tractor. Fill to recommend level, using oil specified in the Proper Torque for
Fasteners Chart in the Maintenance Section.