Filter
Top Products
ASSEMBLY
CONNECT SHIFT ROD
, Insert one end of Shift Rod (Fig 6) into hole of Shift
Lever Indicator..
• Swing Shift Rod to the right side of Tiller and insert
one of two Hairpin Clips through hole of Shift Rod.
ATTACH THIS END
TO SHIFT LEVER ATTACH THIS END
INDICATOR TO SHIFT LEVER
' /
SHIFT ROD
FIGURE 6
SHIFT LEVER
SHIFT ROD
HAIRPIN
CLIP
SHIFT
ROD
HAIRPIN CLIP
SHIFT
LEVER
INDICATOR
FIGURE 7
. insert other end of Shift Rod into hole in Shift Lever
(Fig. 8)
• insert second Hairpin Clip throughhole of Shift Rod.
REMOVE TILLER FROM CRATE
• Make sure Shift Lever Indicator (Fig 7) is in "N" posi-
tion._
• Tilt Tiller forward by lifting Handle Separate cardboard
cover from leveling shield.
• Rotate Tiller Handle to the right and pull Tiller out of
Carton
FIGURE 8
TIRE PRESSURE
Reduce Tire pressure to 20 PSI (Tires were overinflated
for shipping purposes). If'Tire pressures are not equal,
Tillerwill pull to one side
CABLE CLIP
Insert Plastic Cable Clip into hoEeon the back of Handle
Column. Push Cables into Clip (Fig. 9)
ADJUSTMENTS
Refer' to Service and Adjustments Section (page 17) to
adjust Handle height
HANDLE
COLUMN
CABLES
CLIP
FIGURE 9
8