Filter
Top Products
ASSEMBLY
UNPACKING CARTON
BE CAREFUL OF EXPOSED STAPLES
WHEN HANDLING OR DISPOSING OF
CARTONING MATERIAL.
.... H,H,
CAUTION: WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH
OR KINK CABLES,,
. While holding Handle Assembly, cut Cable Ties secur-
ing Handle Assembly to Top Frame and Depth Slake°
Let Handle Assembly rest on Tiller.
• Remove Top Frame of Carton.
• Slowly ease Handle Assembly up and place upside
down on top ofCarton (Fig. 2).
FIGURE 2
• Cut down right hand front and right hand rear corners
of Carton, lay side carton wall down.,
• Remove packing material from Handle Assembly,,
• Separate Shift Rod from Handle Assembly,
INSTALL HANDLE
• Insertone Handle Lock (with teeth facing OUTWARD)
in Gearcase Notch (Fig. 3). (Apply grease on smooth
side of Handle Lock to aid in keeping Lock in place
until Handle is lowered into position)°
GEARCASE GEARCASE
NOTCH
HANDLE
LOCK
Grasp Handle Assembly. Hold in "UP" position (Fig.
4), Be sure Handle Lock remains in Gearcase Notch,,
Slide Handle Assembly onto Gearcaseo
f ,...-..= "UP" POSITION
"": "" ', ', _GF'_'_EN HANDLE
"_._ "',", I LOCK LEVER TO
_?'_ " "t HOLD
HANDLE ==,_'_. ', -, ....
z
FIGURE 4
• Rotate Handle Assembly down to install two Carriage
Bolts and Lock Nuts, Insert rear Carriage Bolt (Fig,,5)
first, with head of Bolt on L.H. side of Tiller, Lower the
Handle Assembly,,Tighten Bolts so Handle moves with
some resistance.
• Insert second Handle Lock (with teeth INWARD) inthe
slot-of the Handle Base (Fig,,5)°
- Place Flat Washer on threaded end of Handle Lock
Lever.,
• Insert Handle Lock Lever through Handle Base and
Gearcase.
• With Handle Assembly in lowest position, securely
tighten Handle Lock Lever by rotating clockwise ((_)o
Leaving Handle Assembly in lowest position wilt make
it easier to remove Tiller from Carton,
GEARCASE HANDLE
LOCK
\
SLOT \ / FLAT
c,
BOLT / / .ANDLE
"_'_-.JJ_- _ _,./ LOCK
CARRIAGE / ? /
BOLT LOCKNUT
HANDLE LOCKNUT
BASE
FIGURE 3
FIGURE 5
7