Filter
Top Products
48
OPERACIÓN
Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto.
Aprenda y comprenda sus significados.
PELIGRO, GUARDE LAS
MANOS Y LOS PIES LEJOS
RUEDA LIBRE
(Solamente para los
modelos automatico)
MANTENGA EL
AREA DESPEJADA
MANTENGA EL
AREA DESPEJADA
PELIGROS DE
PENDIENTES
15
15
(Vea la sección de las reglas de seguridad)
BATERÍA
MARCHA
ATRÁS
MARCHA
HACIA ADELANTE
RÁPIDO
LENTO
MOTOR
ENCENDIDO
MOTOR
APAGADO
LUCES
ENSENDIDAS
COMBUSTIBLE
ESTRANGU-
LACIÓN
ALTURA DE LA
SEGADORA
MARCHA ATRÁS
NEUTRO
ALTO
BAJO
ACCESORIO DEL
EMBRAGUE
ENGANCHADO
FRENO DE
ESTACIONAMIENTO
ACCESORIO DEL
EMBRAGUE
DESENGANCHADO
MOTOR
EN MARCHA
LEVANTAMIENTO
DE LA SEGADORA
No seguir las siguientes instrucciones
puede provocar heridas o muerte. Los
símbolos de aviso de seguridadse utilizan
para identificar informaciones de seguridad
relativas a peligros que puedenprovocar la
muerte, heridas graves y/o daños a la
máquina.
PELIGRO indica un peligro que, si no se evita,
provoca muerte o lesiones graves.
ADVERTENCIA indica un peligro que, si no se evita,
puede provocar muerte o lesiones graves.
PRECAUCIÓN indica un peligro que, si no se evita,
puede provocar lesiones ligeras o moderadas.
PRECAUCIÓN cuando se utiliza sin el símbolo de aviso,
indica una situación que puede provocar daños al
tractor y/o al motor.
FUEGO indica un peligro que, si no se evita, puede
provocar la muerte, lesiones graves y/o danos
a la máquina.
SUPERFICIES CALIENTES indica un peligro que,
si no se evita, puede provocar la muerte, lesiones
graves y/o danos a la máquina.
SISTEMA
FUNCIONAMIENTO
ATRÁS (ROS)
PEDAL DE FRENO /
DE EMBRAGUE
PALANCA DE MANDO
CRUCERO
25
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Clean debris from steering plate.
Debris can restrict clutch/brake pedal
shaft movement, causing belt slip and
loss of drive.
CAUTION: Avoid all pinch points and
movable parts
• Keep finished surfaces and wheels
free of all gasoline, oil, etc.
• Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose
or pressure washer to clean your tractor
unless the engine and transmission are
covered to keep water out. Water in engine
or transmission will shorten the useful life of
your tractor. Use compressed air or a leaf
blower to remove grass, leaves and trash
from tractor and mower.
Steering System, Dash,
Fender and Mower Not Shown
Clutch/brake pedal
Steering
Plate
Clean
top side
CAUTION:
Pinch
Points
DECK WASHOUT PORT
Your tractor’s deck is equipped with a
washout port on its surface as part of its
deck wash system. It should be utilized af-
ter each use.
1. Drive the tractor to a level, clear spot
on your lawn, near enough to a water
spigot for your garden hose to reach.
IMPORTANT: Make certain the tractor’s
discharge chute is directed AWAY from your
house, garage, parked cars, etc. Remove
bagger chute or mulch cover if attached.
2. Make sure the attachment clutch control
is in the “DIS EN GAGED” position, set
the parking brake, and stop the engine.
3. Thread the nozzle adapter (packaged
with your tractor’s Operator’s Manual)
onto the end of your garden hose.
Washout Port
Nozzle
Adapter
Hose
4. Pull back the lock collar of the nozzle
adapter and push the adapter onto the
deck washout port at the left end of the
mower deck. Release the lock collar to
lock the adapter on the nozzle.
IMPORTANT: Tug hose ensuring connec-
tion is secure.
5. Turn the water on.
6. While sitting in the operator’s position
on the tractor, re-start the engine and
place the throttle lever in the Fast " "
position.
IMPORTANT: Recheck the area making
certain the area is clear.
7. Move the tractor’s attachment clutch
control to the “ENGAGED” position.
Remain in the operator’s position
with the cutting deck engaged until the
deck is cleaned.
8. Move the tractor’s attachment clutch
control to the “DIS EN GAGED” posi-
tion. Turn the ignition key to the STOP
position to turn the tractor’s engine off.
Turn the water off.
9. Pull back the lock collar of the nozzle
adapter to disconnect the adapter from
the nozzle washout port.
10. Move the tractor to a dry area, prefer-
ably a concrete or paved area. Place
the attachment clutch control in the
“ENGAGED” position to remove excess
water and to help dry before putting the
tractor away.
WARNING: A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
• Replace broken or missing washout fitting
immediately, prior to using mower again.
• Plug any holes in mower with bolts and
locknuts.