Filter
Top Products
WING
INTERNAL/
EXTERNAL
LOCKWASHER
\
BATTERY
BOLT
FIGURE 6A
WING
NUT
INTERNALIEXTERNAL
LOCKWASHE R
TERMINAL
GUARD
4, Install Battery using: two Int./Ext Lockwashers,,two Wing
Nuts (shown full size below} and
q=D
0
two Battery Bolts and one Terminal Guard found in Bag of
Parts.
ao Using the slot on one side of the Battery Support (Fig.
6A) slide Battery Bolt into Frame Slot (head of Bolt
down}. Fasten the Battery Bolt to the Terminal Guard
using IntjExt° Lockwasher and Wing Nut as shown in
Fig. 6Ao
b. Assemble the remaining Battery Bolt to other side of
Battery Support and fasten Terminal Guard to it with re,
maining Int,/E_t_ Lockwasher and Wing Nut° Tighten
Wing Nuts securely by hand (Fig. 6A).
NOTE: USE TERMINAL ACCESS DOORS (F tG.6A) FOR:
1, Inspection for secure connections (tighten hardware).
2. inspection for corrosion,
3, Testing battery,
4, Jumping (if required).
5_ Charging (if required).
SCREW
FIGURE 7
HEADLIGHT
CONNECTION
/
WHEN NOT IN USE, KEEP TERMINAL
ACCESS DOORS CLOSED,
NOTE: DO NOT START ENGINE UNTIL INITIAL SER-
VICE HAS BEEN PERFORMED,
INITIAL ADJUSTMENTS
1. TIRE PRESSURE
Reduce Tire pressure to t4 PSI in front tires; 12 PSI in
rear tires, (Tires were overinflated for shippingL
. HOOD
a. To raise Hood, lift at rear of Hood.
b. Unsnap Headlight Connection (Fig, 8).
c,. To remove Hood, Grill and Side Panels, raise Hood and
loosen one screw on each Side Panel. (The screw remains
in the Side Panel) (Fig, 7)._
d, Stand in front of Tractor_ Grasp Hood and titt forward
and lift off (Fig. 8),
e, To reinstall, reverse above procedure..
FIGURE 8 - 6 -