Filter
Top Products
ASSE BLY
HOW TO SET UP YOUR TRACTOR
PREPARE BAKERY (SeeFig,21
CAUTION: Wear eye a_d face shield.
Wash hands or c_othing _rnmedlately if
accidentally in contact with battery acid.
Do not smoke. Fumes from charged
battery acid are e×p_osiveo
Read the instructions included with the
battery vent ¢apso Always wear gloves,
c_othing and goggles to protect your
hands_ skin and eyes.
Your unit has a battery charging system which is sufficient
for normal use. However, periodic charging of the battery
with an automotive charger writ extend its life.
o See instructions packed with vent caps in parts bag.
o Fil! battery with acid. Fill each celt until it reaches the
bottom of the vent wetIs. Do not overfill.
Allow battery to stand and settle for at least thirty
minutes. After standing, check the level of acid. if
beiow the vent wells, add more acid until the correct
level is reached.
Wah)/e,_ttt __iri)_jSet_n d_negd!tftoe_a111 _ _cal)ae_y {_ whi_?
_MPORTANT: TO MAXIMIZE THE UFE OF YOUR
BATTERY, iT IS NECESSARY THAT THE BATTERY BE
CHARGED BEFORE USE. FAILURE TO CHARGE
BATTERY CAN RESULT iN A SHORTENED BATTERY
LIFE.
o Charge battery at a rate of 6 amperes for ! hour. Use
a 12 volt battery charger. Observe all safety precautions
required for battery charging.
o Check the acid levet after the battery is charged. If the
acid has fallen below the correct level, add distilled or
iron free water.
o hstalt the vent caps to cover the vent wells. Wash the
top of the battery with water to remove any acid, then
w_pe dry.
o Check battery case for leakage to make sure that no
damage has occurred in handling.
• Dispose of excess battery acid. Neutralize acid for
disposal by adding it to four inches of water in a five
gallon plastic container. Stir with a wooden or plastic
paddle while adding baking soda until the addition of
more soda causes no more foaming.
o Follow instructions on how to instalI battery.
_NSTALL SEAT (See Fig, 3}
Adjust seat before tightening adjustment bolt.
o Remove cardboard packing on seat pan,
° P_ace seat on pan and assemble shoulder bolt.
• Assemble adjustment bolt, tock washer and flat washer
loosely. Do not tighten,
• Tighten shoulder bolt securely.
o Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down
(See Fig. 6).
• Get off seat without moving its adjusted poskion.
• Raise seat and tighten adjustment bolt securely.
/
ADJUSTMENT
BOLT
FLAT WASHER
LOCK WASHER
FIG. 3
CHECK TIRE PRESSURE
The tires on your unit were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
• Reduce tire pressure to PSI shown in "PRODUCT
SPECIFICATIONS" on page 3 of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POS T ON OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section of this manual. Verify that the be!ts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted. See "TO ADJUST
BRAKE" in the Service and Adjustments section of this
manual
F_G. 2 8