Filter
Top Products
......... i
OPERATION
The operation of any tractor can result in foreign objects thrown into the eyes, which can
result in severe eye damage. Always wear safety glasses or eye shields while operating
your tractor or performing any adjustments or repairs. We recommend wide vision safety
mask for over the spectacles or standard safety g_asses, available at Sears Retail or
Catalog stores.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 7)
Your unit is equipped with an operator presence sensing
switch. When engine is running, any attempt by the
operator to leave the seat without first setting the parking
brake wilt shut off the engine.
. Depress clutch/brake pedal into full "BRAKE" position
and hold.
Place parking brake lever in "ENGAGED" position and
release pressu refrom cfutchibrake pedal. Pedal should
remain in "BRAKE" position. Make sure parking brake
wilt hold vehicle secure.
ENGINE -
Move throttle control to "SLOW" position.
Turn ignition key to "OFF" position and remove key.
Always remove key when leaving vehicle to prevent
unauthorized use.
, Never use choke to stop engine.
NOTE: Under certain conditions when unit isstanding idle
with the engine running, hot engine exhaust gases may
cause "browning" of grass. To eliminate this possibility,
always stop engine when stopping unit on grass areas.
ATTACHMENT "DISENGAGED"
CLUTCH LEVER POSITION
"ENGAGED"
POSITION \"_ BRAKEPARKING
"ENGAGED"
POSITION
CHOKE
CONTROL
LEVER
MOTION
CONTROL
LEVER
IGNIT|ON
KEY
"BRAKE"
POSITION
\
CLUTCH/BRAKE
PEDAL "DRIVE"
POSITION
\
PARKING BRAKE
"DISENGAGED"
POSITION
FIG. 7
STOPPING (See Fig, 7)
MOWER BLADES -
Move attachment clutch lever to "DISENGAGED" po-
sition.
GROUND DRIVE -
• Depress clutch/brake pedal into ful! "BRAKE" position.
, Move motion control lever to "NEUTRAL" position.
iMPORTANT; THE MOTION CONTROL LEVER DOES
NOT RETURN TO "NEUTRAL" POSITION WHEN THE
CLUTCH/BRAKE PEDAL IS DEPRESSED.
TO USE THROTTLE CONTROL (See Fig. 7)
Always operate engine at full throttle.
• Operating engine at less than full throttle reduces the
battery charging rate and the engine cooling air flow.
o Full throttle offers the best bagging and mower per-
formance.
11
TO MOVE FORWARD AND BACKWARD (See
Fig. 6)
The direction and speed of movement is controlled by the
motion control lever.
• Start tractor with motion control lever in "NEUTRAL"
position.
, Release parking brake and clutch/brake pedal.
Slowly move motion control lever to desired position.
TO ADJUST MOWER CUTTING H_I_T l_,_,=
Fig. 6)
The position of the attachment lift lever determines the
cutting height,
o Grasp lift lever,
. Press plunger with thumb and move lever to desired
position.
The cutting height range is approximately 1-t/2" to 4". The
heights are measured from the ground to the blade tip with
the engine not running. These heights are approximate
and may vary depending upon soil conditions, height of
grass and types of grass being mowed,
o The average lawn should be cut approximately 2-t/2
inches during the cool season and over 3 inches during
hot months, For healthier and better looking lawns,
mow often and after moderate growth,
o For best cutting performance, ..qr_c_ov_r 6 inches in
height should be mowed twice. Make the first cut
relatively high; the second to desired height.