Filter
Top Products
SERVUCE AND ADJ STMENTS
TO REPLACE HEADLIGHT BULB
, Raise hood.
= Pull bulb holder out of the hole in the backside of the
grill.
= Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
, CIosehood_
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor' to run
poorly, stop running, or prevent itfrom starting.
= Check wiring_ See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type pfug-in fuse. The
fuse holder' is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 28)
• Raise hood..
o Unsnap headlight wire connector_
= Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor..
• To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 28
24