Filter
Top Products
A SSEMBL Y
STEERING
WHEEL
iNSERT
FIGURE 3
AIR
INTAKE HOO0
DuCT
,\
FIG URE 4
3. Install Steering Wheel
NOTE POSITION FRONT WHEEL FORWARD
a Use a 3/4 wrench to remove tock nut and
2 - t/4-" diameter washer (shown full size below)
from steertng column (Fig 3t
G
b. Position steering wheel over.steering wheel insert (Fig,,
3), BARS OF STEERING WHEEL SHOULD POINT
STRAIGHT ACROSS TRACTOR
c Secure steering wheel to steermg column usmg
2 I/4 dtameter washer and fock nut (F_g 3)
Torque to 68 N-m (50 Ft Lbs,.)
d Snap steenng wheel cap in place on steering
wheel Steermg v_heei cap found tn bag of parts
4. Check Tires
Reduce tire pressure to I Kg/crrF (14 PSI) in front t#es
and O,71 Kg/cn'F (10 PSI) in rear tires.. (Tires were
overinftated for shipping purposes,.)
5 Install Battery
!_ DO NOT SHORT BATTERY TERMINALS
BEFORE INSTALLING BATTERY, REMOVE
METAL BRACLETS. WRISTWATCH BANDS,
.... RINGS.:,ooETC' : ................................
I&..... I
tF BATTERY IS REMOVED, DO NOT
OPERATE ENGINE. SPARKING MAY
OCCUR.
a Lift hood from rear srdes (F_g 41
b Make sure drain tube (Fig 5) is fastened to drain
hole in battery tray and battery tray is position.
ed in hole of battery support
c Place battery in plastic tray (battery terminals to
front of tractor) (Fig 5)
1
POSITIVE TERMINAL MUST BE CONNEC,- I
TED FIRST TO PREVENT SPARKS FROM
1
ACCIDENTAL GROUNDING