ASSEMBLY
6
CONTAINER MOUNTING
(See Fig. 7)
No hardware required
• Install one container to left side first with warning to
outside of unit. Install other container to right side.
NOTE: Right container should always overlap left con-
tainer at center support.
• Close cover and lock latch handle over center support
tube.
COVERLATCH
HANDLE
CONTAINER
CONTAINER
HANDLE _ CENTER
SUPPORT
CONTAINER
3
Fig. 7
7
LOWER CHUTE (See Fig. 8 & 9)
Use Hardware-- GROUP "D"
• Install two latch hook assemblies, to lower chute using
screw, washer, lock washer, and weld nut as shown
° Tighten hardware securely_
• Raise and hold deflector shield in upright position
° Place front of chute over front of mower deck opening
and slide into place, as shown
= Hook front latch into tab hole on front of mower deck
• Hook rear latch into tab hole on back of mower deck.
• If your tractor is equipped with gage wheels on the
deck, then it will be necessary to use the hole in the
R.H. gage wheel mounting bracket•
CAUTION: Do not remove discharge guard I
from mower. Raise and hold guard when
attaching lower chute and allow it to rest
on chute while in operation.
SCREW
LOCK WASHER
WITH OUT Fig. 8
GAGE fJ"_
WHEELS ......•_ DEFLECTOR
©
9
WITH
GAGE
WHEELS
Fig. 9a
DEFLECTOR
" " SHIELD
