Filter
Top Products
1
REAR MOUNTING BRACKET
(See Figs. 1 & 2)
Use Hardware - - GROUP "A"
Only one set of hardware in GROUP "B" will be used to
mount the rear mounting bracket. To determine which set
is correct for your tractor, check to see if there are (2) two
upper corner ribs on each side of drawbar, tfyour tractor
has the upper corner ribs, use the (4) four self tapping bolts
If your tractor does not have the corner ribs, use the set of
(4) four bolts and Iocknuts
SELF TAPPING BOLTS
• Assemble the mounting bracket, lanced tabs towards
bottom, using the four formed holes on the drawbar
NOTE: Start the self tapping bolts into holes on the
drawbar at least two full turns and remove. This will make it
much it much easier to fasten the bolts once the mounting
bracket isin place
= Install the four bolts as shown and tighten securely
UPPER CORNER
RIBS
UPPER CORNER
RIBS
SELF
TAPPING
BOLTS Fig. 1
BOLTS AND LOCKNI, JTS
= Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller inside holes on the
drawbar,
• Install the four bolts and Iocknuts as shown and tighten
securely
BOLTS
LOCKNUTS
LANCED TABS TOWARD BOTTOM
Fig. 2
BLY
COVER SEAL (See Fig. 3)
No hardware required
Align mark on seal with mark at cover opening
Work seal into opening so cover sits between flanges
of seal
ALIGNMENT
MARKS
COVER SEAL
Fig. 3
SUPPORT POST (See Fig. 4)
Use Hardware - - GROUP "B"
I_ CAUTION: Container support is spring I
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
• Rotate cover assembly onto its side as shown.
• Assemble support post to container support with the
three (3) hex bolts and Iocknuts. Tighten securely_
HEX BOLTS
SUPPORT
POST
/• / •
/
/
LOCKNUTS
Fig. 4
7