Filter
Top Products
ASSEMBLY
= Using a 5/16" (8mm) wrench, attach wire support totop
two holes of guide handle with #10 self-drillingscrews
and #10 flat washers (Fig. 3), The hose minder should Q
be to the left and _unholder to the right° Be sure loop
of support is pointing upward. Place vinyl cap onto gun
holder.
VINYL CAP
WIRE SUPPORT
J
FIG. 3
FASTENERS
TO ASSEMBLE REMAINING COMPONENTS
IMPORTANT: YOU MUST ASSEMBLE WAND AND AT-
TACH ALL HOSES BEFORE YOU START ENGINE.
STARTING ENGINE WITHOUT ALL HOSES CON-
NECTED AND WATER SUPPLIED WILL DAMAGE
PUMP.
PUMP
DIPSTICK
FIG. 4
Remove the red cap
from the oil fill hole on
thepump and insert Oil
Fill Cap (Fig. 4),
Included with this unit is a Quick-Connect fitting you
attach to Water Inlet. The quick-connect includes two
parts -- a Male Connector factory-installed on water
infet and a Female Connector (Fig. 5). Remove male
connector to inspect Intake Supply Screen in water inlet
for cleanliness and inspect Inlet Screen on female
NLET
FEMALE
CONNECTOR
INLETSCREEN
FIG. 5
connector. Reattach male connector to water inlet and
attach female connector to garden hose.
Unravel highpressure hose, remove plasticcap on end
of hose and checkother end of|lose to see thatthreads
are properly covered with teflon tape. If tape is not
properly applied, reapply it sothreads are fully covered.
The tape seals the connection from hose to gun and
wand assembly°
Attach fitting with teflon tape to gun and wand assembly
(Fig. 6). You may want to sp=ngun or spin hose to
secure connection. Tighten hose using 11/16" and 7/8"
wrenches.
• !\
FIG. 6
,= Attach the other end of the high pressure hose to high
pressure fitting on pump (Fig° 7)° Tighten with 15t16
(24mm) wrench.
I
.laHPR SSd j
HIGH PRESSURE
HOSE
FIG. 7
o To attach the adjustable nozzle refer to Operation
section, Fig_10,,
CHECKLIST
° Check that fasteners you used to install wheel kit and
handles are tighL Vibration during operation may
loosen fasteners that are not tight enough.
• Check for proper hose connections (high pressure and
water supply) and for tight connections and that there
are no kinks, cuts, or damage to high pressure hose.
• Provide proper water supply (not to exceed t40°F)o
o Be sure to read "Safety Rules" and "Operation" sec-
tions before using the pressure washer.