Filter
Top Products
CUSTOMER RESPONSIBJLITIIES
iii
MAINTENANCE SCHEDULE
FiLL IN DATES AS YOU COMPLETE
REGULAR SERVICE
MAINTENANCE TASK
PRESSURE WASHER
Chock/clean inletfilter and screen
Chock high pressurehose.
Check detergent hose.
Check gun and wand for leaks.
Chock pump oil.
ENGINE
Chock oil level.
Change engine oil. _,
Serviceair'cleaner.
Replace/clean spark plug.
Prepare for storage.
HOURLY OPERATING INTERVAL
Before
Each Use
xt
X
X
X
X
Every25
Hours or
Yearly
X_
After First
50Hours
x$
Every100
Hours or
Yearly
X*_
X
Prepare unitfor storage ifit isto remain idle
longerthan30 days
1"Clean if clogged. Replace if perforated or tom
I: Change oil after first 50 operating hours, then after every 500 hours or yearly.
Change oil after first 5 hours, then after every 25 hours°
* Change sooner when operating under heavy load or high ambient temperature°
SERVICE DATES
GENERAL RECOMMENDATIONS
The warranty of the high pressure washer does not cover
items that have been subjected to operator abuse or neg-
ligence. To receive full value from the warranty, operator
must maintain high pressure washer as instructed in this
manual.
Some adjustments will need to be made periodically to
properly maintain your high pressure washer.
All adjustments in the Service and Adjustments section of
this manual should be made at least once each season.
Once a year you should replace the spark plug and
clean or replace the air filter and check the gun and
wand assembly for wear° A new spark plug and clean
air filter assure proper fuel-air mixture and help your
engine run better and last longer.
BEFORE EACH USE
,, Check engine oil level.
• Check water inlet filter and quick-connect screen for
damage.
,, Check high pressure hose for leaks.
• Check detergent inlet hose and filter for damage.
,, Check gun and wand assembly for leaks.
PRESSURE WASHER MAINTENANCE
DANGER: WATER SPRAYING FROM A LEAK iS t
CAPABLE OF INJEC_NG MATERIAL INTO SKIN.
NEVER REPAIR HIGH PRESSURE HOSE. RE-t
PLACEWITH HOSETHAT MEETS MINIMUMPRES- t
SURE RATING OF YOUR PRESSURE WASHER, J
Check Inlet Filter and Screen: Remove quick-connect and
examine inlet screen on thefemale connector and filter onpump
inlet fitting.Clean if either isdogged or replace ifeither istom.
Check High Pressure Hose: High pressure hose can
develop leaks from wear, kinking, abuse_ Inspect hose
each time before using it. Check for cuts, leaks, abrasions
or bulging of cover, or damage or movement of couplings.
If any of these conditions exist, replace hose immediately.
Check Detergent Hose: Examine the filter' on the deter-
gent hose and clean if clogged_ Hose should fit tightly on
barbed fitting. Examine hose for leaks or tears. Replace
the filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection to gun
and make sure it is secure. Test trigger by pressing it and
making sure it springs back into place when you release it.
Put safety latch in ON position and test trigger. You should
not be able to press trigger.
Check Pump Oil: Refer to PUMP MAINTENANCE for
information.
]4