Filter
Top Products
SAFETY RULES
_ AUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CANNOT CON_ _,
TACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING,
ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.
TRAINING:
e EngineexhaustgasescontainDEADLYcarbonmonox-
Ide gas_ This dangerous gas, if breathed in sufficient
concentrations,can cause unconsciousness or even
death. Operate this equipmentonlyin theopen airwhere
adequate ventilation is available.
® Gasoline is highly FLAMMABLE and itsvapors are EX-
PLOSIVE. Do not permit smoking, open flames, sparks
or heat in the vicinity while handling gasoline° Avoid
spilling gasoline on a hot engtne_Allow unitto coolfor 2
minutesbefore refueling. Complywith all lawsregulating
storage and handling of gasoline°
• Locatethis pressure washer inareas awayfrom combus-
tible materials, combustible fumes or dust.
• The highpressure equipment isdesignedto be usedwith
Sears authorized partsonlyo Ifyou usethis equipment
withpartsthatdonotcomplywithminimumspecifications,
theuser assumes all risksand liabilities°
e Somechemicalsordetergentsmay be harmful ifinhaled
oringested,causingseverenausea,faintingorpoisoning
The harmfu!elements may cause propertydamage or
severeinjury_
• DonotallowCHILDRENtooperatethePressureWasher
at any time_
PREPARATION:
e Operate engine only at governedspeed Runningthe
engine at excessive speeds increasesthe hazard of
personalinjury° Do not tamper with parts whichmay
increaseor decrease thegovernedspeed.
o Donot wearlooseclothing,jewelryoranything that may
becaughtinthestarteror otherrotating parts.
• Before startingthe PressureWasher in cold weather,
checkall partsoftheequipment andbe sureicehasnot
formed there.
e Unitswithbrokenor missing parts,or withoutprotective
housingorcoversshouldNEVER beoperated°
= The mufflerand aircleanermust be installedand ingood
condtflonbeforeoperatingthePressureWasher. These
componentsact assparkarrestorsif theenginebackfires
e Checkthefuel systemfor leaksor signsof deterioration
suchas chafedor spongyhose,loose ormissingclamps
ordamagedtankorcap. Correctall defects beforeoper-
atingthe PressureWasher.
OPERATION:
• Do notsprayflammableliquids.
,, Never aimthegunat people,animals orplants.
= Never allow any partofthe bodyto come incontactwith
the fluidstream. DO NOT come in contactwitha fluid
streamcreatedbya leak in thehighpressurehose
= High pressurestream of fluidthat this equipmentcan
producecanpiemaskinand itsunderlyingtissues,lead-
ingtosedous injuryandpossibleamputation
• High pressurespraycan cause paintchipsor otherpar-
ticlesto become airborneandfly at high speeds=
• Always wear eye protection when you use this equipment
or when you are in the vicinity where the equipment isin
use.
e Operate the pressure at no more than the PSI fluid
pressure rated for your pressure washer.
• Never move the machine by pulling on the high pressure
hose. Use the handle provided on the top of the uniL
= Always becertain the spraygun, nozzles and accessories
are correctly attached.
® Never use a spray gun which does not have a trigger lock
or trigger guard in place and in working order:
® Use a respirator or mask whenever there isa chance that
vapors may be inhaled. Read al! instructions with the
mask so you are certain the mask will provide the neces-
sary protection against inhaling harmful vapors
o High pressure spray may damage fragile items including
glass Do not point spray gun at glass when in the jet
spray mode
e Keep the hose connected to machine or the spray gun
while the system is pressurized Disconnecting the hose
while the unit is pressurized is dangerous°
o Hold the spray gun firmly in your hand before you start
the unit, Failure to do so could result in an injury from a
whipping spray gun Do not leave the spray gun unat-
tended while the machine is running.
,D The cleaning area should have adequate slopes and
drainage to reduce the possibilityof a fall due to slippery
surfaces.,
e Keep waterspray away from electric wiring or fatal electdc
shock may resulL
e Do not adjust unloader valve to a pressure in excess of
machine rating_
= Do not secure trigger gun in the pull-back (open) position.
= Do not by-pass any safety device on this machine
o Do not leave tngger closed for more than 5 minutes with
engine running This could damage the pump.
= The muffler and engine heat up during operation and
remain hot immediately after shutting it down. Avoid
contact with a hot muffler or engine or you could be
severefy bumed
MAINTENANCE AND STORAGE:
e Operate and store this unit on a stable sudace,
=, High pressure hose can develop leaks from wear, kinking,
abuse, etc, Water spraying from a leak is capable of
injectingmaterial intoskin, Inspect hose each timebefore
using it. Check all hoses for cuts, leaks, abrasions ol
bulging of cover, or damage or movement of couplings. If
any of these conditions exist, replace hose immediately.
Never repair high pressure hose Replace it with another
hose that meets minimum pressure rating of your pros=
sure washer
LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT
SAFETY PRECAUTIONS. IT MEANS "ATTENTION!It BE-
COME ALERTH! YOUR SAFETY IS INVOLVED."
i