Filter
Top Products
@
)
ASSEMBLY
i i , ill i uuull um Hul ,t
• Place the upper handle on the lower handle (See
Fig. 3B) and secure in place with two (2) 5/16-18 x
1-1/2 inch hex head screws and two (2) 5/16-18
head head Iocknuts {found in parts bag)
• Insert one end of the control rod through the hole in
the clutch lever (See Fig° 4) and attach with a hair
pin (found in the parts bag)°
o Place the clutch lever in the first depth selection and
insert the other end of the control rod through the
hole inthe quill support arm (See Fig 4) Attach with
hairpin (found in parts bag).
o Move the clutch lever to NEUTRAL position and
latch into position,
NOTE: It may be necessary to loosen the four screws
and nuts holding the lower handles to the frame (See Fig.,
5). Pry up (forward) on the handles to allow the clutch
lever to freely enter the NEUTRAL position, Retighten
nuts and screws.
UPPER HANDLE
5116-18HEX 5116-18 HEX
HEAD SCREW SCREW
LOWER
HANDLE
FIG. 3B
CLUTCH
LEVER
HAIR PIN
CONTROL
ROD
HAIR PIN
I
QUILL SUPPORT
ARM
FIGo 4
RIGHT SIDE
LOWER HANDLE
LOWER HANDLE
VIEW FROM RIGHT SIDE OF UNIT
FIG. 5
@
7