Sears 486.245951 Spreader User Manual


 
9
For most vehicles, assemble the hitch extension
bracket to the holes in the hitch tube shown at the
top of gure 16. Use two 1/4" x 1-3/4" hex bolts and
1/4" nylock hex nuts tightened only nger tight. Attach
the spreader hitch to your vehicle hitch. Check for
interference with the spreader directly behind and out
to both sides of the vehicle. Lift the spreader at each
position to make sure there is no interference with the
spreader's ow control. If there is interference with
the rear of the vehicle, assemble the hitch extension
bracket as shown at the bottom of gure 16. Tighten
the bolts and nuts when nished.
FIGURE 16
Assemble the hitch bracket to the hitch extension
bracket using two 3/8" x 3/4" hex bolts (inserted from
the bottom) and two 3/8" nylock hex nuts. See gure
15.
Assemble the hitch pin through the hitch bracket and
the hitch extension bracket and secure with the hair
cotter pin. See gure 15.
1/4" NYLOCK
HEX NUT
1/4" x 1-3/4"
HEX BOLT
3/8" x 3/4"
HEX BOLT
3/8" NYLOCK
HEX NUT
HITCH PIN
1/8" HAIR
COTTER PIN
FIGURE 15
FIGURE 13
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP
(SETTING "5")
ON
OFF
24. Place the screen down into the hopper, sliding the
edge of the screen under one of the clips. Slightly bow
the screen to slide the opposite side of the screen
under the other clip. See gure 14.
FIGURE 14
CLIPS
CLIP
SCREEN