8
• Hook the double bent end of the ow control rod
through the hole in the slide gate bracket located near
the bottom of the hopper. See gure 10.
• Assemble the ow control arm to the ow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock hex nut. Tighten carefully.
The ow control arm should be snug but should pivot
with no more than slight resistance. See gure 9.
FIGURE 9
• Place a 5/16" at washer onto the other end of the
ow control rod. Insert the end of the rod through the
curved slot in the ow control mounting bracket and
through the hole in the ow control link. Secure with
a 5/16" at washer and a 3/32" x 3/4" cotter pin. See
gure 11.
NOTE: You can leave off the second washer if there is
not enough room on the end of the rod.
FIGURE 10
OFF
ON
1
2
3
4
6
7
8
9
10
5
1/4" x 1"
HEX BOLT
1/4" NYLOCK
HEX NUT
NYLON
WASHERS (2)
• Place the adjustable stop into the "ON" end of the slot
in the top of the ow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a
5/16" at washer and the nylon wing nut. See gure
12.
FIGURE 12
FIGURE 11
NYLON
WING NUT
OFF
ON
1
2
3
4
6
7
8
9
10
5
5/16" FLAT
WASHER
NYLON
WASHER
ADJUSTABLE
STOP
1/4" x 3/4"
CARRIAGE BOLT
5/16" FLAT
WASHER
3/32" HAIR
COTTER PIN
FLOW
CONTROL
ROD
OFF
ON
1
2
3
4
6
7
8
9
10
5
5/16" FLAT
WASHER
• Position the ow control mounting bracket. See gure
13.
a. Push on ow control arm until it locks in "OFF"
position.
b. Slide ow control mounting bracket along tube
until closure plate in bottom of hopper just
closes.
c. Snug the 5/16" nylock hex nuts just enough to
hold ow control mounting bracket in place.
d. Set adjustable stop at "5". Pull ow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of ow control mounting bracket until
closure plate will open about half way at "5"
and will still close when arm is locked in "OFF"
position. Tighten the 5/16" nylock hex nuts.
