Filter
Top Products
15
ADAPTER BRACKET
5/16" flat washers
used as needed for
shims to adjust for
variations in decks.
(2) 5/16" NYLOCK
NUTS
5/16" x 1-1/4"
HEX BOLT
(2) 5/16" FLAT
WASHERS
(3) 1/4" NYLOCK
NUTS
(3) NYLON
WASHERS
(3) 1/4" STEEL WASHERS
(3) 1/4" x 1" HEX BOLTS
ADAPTER
BRACKET
MOWER DECK
DECK ADAPTER
7. Assemble the adapter bracket to the deck using two
5/16" x 1-1/4" hex bolts, 5/16" at washers and 5/16"
nylock nuts. See gure 32.
NOTE: It may be necessary to use extra 5/16" at washers
to shim under the bracket next to the deck surface. Ten extra
washers have been furnished as shims. See gure 32.
8. With deck adapter positioned correctly over the discharge
opening, use the adapter bracket as a template and
drill three 9/32" diameter holes in the top of the deck
adapter. See gure 33.
9. Bolt deck adapter to bracket using three 1/4" x 1" bolts,
nylon washers, 1/4" at washers and 1/4" nylock nuts.
Nylon washers should be against the inside of the deck
adapter. See gure 33.
10. Assemble end of hose and a hose clamp over the round
opening of deck adapter and tighten clamp.
GO DIRECTLY TO OPERATION INSTRUCTIONS ON
PAGE 16.
FIGURE 32
FIGURE 33