Filter
Top Products
13
1/4" x 3/4"
HEX BOLT
1/4"
NYLOCK
NUT
1/4"
WASHER
1/4"
WASHER
1/4" x 1"
HEX BOLT
#10-32 x 5/8"
TRUSS BOLT
ROPE
SECURE
ROPE
KNOT
#10-32
NYLOCK
NUT
CLIP
11. Place the top angle support and cart bag ontop of the
cart as shown in gure 27. Then, using a screwdriver
or other sharp object, poke holes through the cart bag
for the bolts that will be assembled in step 12.
12. Attach the top angle support and braces to the cart using
seven 1/4" x 3/4" hex bolts, fourteen 5/16" washers (one
placed on each side) and seven 1/4" nylock nuts. DO
NOT TIGHTEN YET. See gure 27.
NOTE: Cart bag not shown for clarity.
FIGURE 27
13. Slide each end of the rope through the holes in the
tailgate shown in gure 28.
14. Tie a knot in the end of each side of the rope to secure
the rope in place. Keep knot loose. See gure 28.
HINT: Knot may need to be moved up or down in rope to
secure tailgate. See step 18 for more information.
15. Slide tailgate into tailgate guides.
16. Attach clips to 3rd lower support rod and fasten them
to the tailgate using two #10 x 5/8" slotted head bolts
and #10 nuts. See gure 28.
17. TIGHTEN all bolts assembled in steps 7 through 12.
18. Secure tailgate rope around the bolts shown in gure
28. If rope does not keep tailgate held down or rope
is too short to secure around bolts, move the knot up
the end of the rope to loosen or down to tighten. Once
knot is in desired location, tighten the knot to secure it
in place.
NOTE: Cart bag not shown for clarity.
FIGURE 28
While performing the assembly operations
in step 11, make sure the cart bag is between
the top angle support and the cart.