Filter
Top Products
7
9. Assemble the front panel over the opposite end of the
cart using four 1/4" x 3/4" hex bolts and 1/4" nylock
nuts as shown in gure 4. Leave two holes open in the
bottom of the panel as shown in gure 4. With the cart
body halves pulled together, tighten the two bolts in the
bottom of the front panel, then tighten the bolt in each
side.
At this time tighten the two bolts on the bottom of the
cart which were assembled in step 4.
10. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" nylock nuts as
shown in gure 5. Heads of bolts go on the inside of
cart. Tighten.
1/4" x 3/4"
HEX BOLT
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK NUT
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
FIGURE 4
5/16"
NYLOCK
NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
1/4" x 3/4"
HEX BOLT
LATCH STAND BRACKET
1/4" HEX NUT
ALIGNING TAB
AT BOTTOM
1/4" x 3/4"
HEX BOLT
1/4" NYLOCK
NUT
FIGURE 5
11. Turn the latch stand bracket so that the aligning tab is
at the rear (bottom) of the bracket. Assemble the latch
stand bracket to the cart using four 1/4" x 3/4" hex bolts
and 1/4" nylock nuts. Tighten. See gure 6.
12. Assemble two 1/4" x 3/4" hex bolts and 1/4" nylock
nuts to the two rear corners of the cart. Tighten. See
gure 7.
FIGURE 7
FIGURE 6