Filter
Top Products
15
LUBRICATION & MAINTENANCE
X Check all hardware for tightness
X Check all belts for proper alignment
X Check engine oil level See engine operator's manual
X *Clean air cleaner element See engine operator's manual
X Check operator presence system See page 5
X Check tire pressure See page 8
X Check belt tension See page 9
X Sharpen cutter blades See page 11
X Check hydraulic oil level See page 16
X *Clean mower See page 17
X Change engine oil and filter See engine operators manual
X Grease spindle bearings + US Lithium MP White Grease 2125
X Check hydraulic oil level See page 16
X Change engine oil See engine operator's manual
X Check all belts for proper alignment
X *Replace air filter element See engine operator's manual
X Grease caster wheel bearings Chassis grease
X Check all hardware for proper tightness More often if needed
X Grease brake hand lever Chassis grease
X Grease brake actuator levers Chassis grease
X Drain hydraulic system and replace oil & filter See page 16
X Grease caster wheel pivot shafts ** Chassis grease, see instructions below
X Replace engine fuel filter See engine operator's manual;
X Adjust air gap on electric clutch Contact your Scag dealer for information about
this maintenance procedure.
BREAK-IN
8 HOURS (DAILY)
20 HOURS
40 HOURS (WEEKLY)
100 HOURS (BIWEEKLY)
500 HOURS OR ANNUALLY
COMMENTS
PROCEDURE
+ Grease spindle until grease comes out the relief valve.
Compatible Greases: Lidok EP #2 (found at industrial shops)
Ronex MP (Exxon service stations)
Shell Alvania (Shell service stations)
Mobilux #2 (Mobil service stations)
Super Lub M EP #2 (Conoco service stations)
* Perform these maintenance procedures more frequently under extreme dusty or dirty conditions.
**PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install
standard grease zerk (p/n 48114-06). Apply grease to the fitting until new grease appears at the top of the
caster extension. Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part
number 47007, is recommended for use in the installation of the grease cap.