Filter
Top Products
6
BEFORE OPERATION CONSIDERATIONS
(CONT'D)
B. Be alert for holes, rocks, roots and other hidden
hazards in the terrain. Keep away from any
dropoff. Beware of overhead obstructions (low
limbs, etc), underground obstacles (sprinklers,
pipes, tree roots, etc.). Cautiously enter a new
area. Be alert for hidden hazards.
10. If the mower discharge ever plugs, shut off the
engine, remove the ignition key, and wait for all
movement to stop before removing the obstruction.
WARNING:
DO NOT operate on steep slopes. To check a slope,
attempt to back up it (with the cutter deck down). If
the machine can not back up the slope without the
wheels slipping, do not operate the machine on this
slope.
ALWAYS travel across the slope whenever possible.
Never up and down the slope.
Reduce speed and use caution when turning, operating
on slopes, slick or wet surfaces. Allow extra distance
to stop.
Operate the machine smoothly, no sudden turns,
starts or stops on a slope.
ALWAYS be sure of your footing. Keep a firm hold on
the handles and walk---never run.
DO NOT mow near drop-offs, ditches or embankments.
The machine could suddenly roll over if a wheel goes
over the edge or if the edge caves in.
DO NOT permit untrained personnel to operate the
machine.
ALWAYS FOLLOW OSHA APPROVED OPERATION
7. Disengage power to the cutter deck before backing
up. Do not mow in reverse unless absolutely
necessary and then only after observation of the
entire area behind the mower. If you must mow in
reverse, maintain a constant lookout to the rear of
the machine and mow slowly.
WARNING:
DO NOT use your hand to dislodge the clogged
discharge chute. Use a stick or other device to
remove clogged material after the engine has
stopped running and the blades have stopped
turning.
6. Using the machine demands attention. To prevent
loss of control:
11. Check the blade mounting bolts at frequent intervals
for proper tightness.
OPERATION CONSIDERATIONS
1. Before operating the mower, familiarize yourself
with all mower and engine controls. Knowing the
location, function and operation of these controls is
important for safe and efficient operation of the
mower.
12. Make sure all hydraulic fluid connections are tight
and all hydraulic hoses and lines are in good condition
before starting the machine.
2. Start the engine when the neutral latches are in the
neutral lock position, the cutter blades are disen-
gaged, the parking brake is on and the speed adjust-
ment lever is in the neutral position.
3. Be sure the interlock switches are functioning
correctly.
4. DO NOT mow when children and/or others are
present. Keep children out of the mowing area and in
the watchful care of a responsible adult other than
the operator. Be alert and turn the machine off if a
child enters the area.
5. DO NOT carry passengers.
A. Mow only in daylight or when there is good
artificial light.
8. Disengage power to the cutter deck before crossing
roads, walks or gravel drives. Stop blades if not
mowing.
9. Shut the engine off and wait until the blades come to
a complete stop before removing the grass catcher
container.
10. Never raise the cutter deck while the blades are
rotating.