Sanus Systems CFAR47 Patio Furniture User Manual


 
Step 14: Secure Wall Bracket to wall
Locate two wood studs using a stud nder. It is a good idea to verify where the stud is with a awl or a thin nail. Mark the location of each
stud. To nd the height, measure 54 inches up from the oor. Mark the location on the stud. Drill a 2.5” deep hole with a 3/16” drill bit
at each marked location. Insert a Lag Bolt (p) through a Lag Bolt Washer (q), a Wall Bracket and drive it into the pre-drilled hole until
secured into the stud. The Wall Brackets can be positioned either as shown on the left or the right in Diagram 14 to help account for slight
measurement discrepancies. See Diagram 14 for assistance.
Diagram 14
q wall stud
p bb
Step 15: Secure Assembly to wall
Secure the Furniture Brackets (aa) to the Wall Brackets (bb) by inserting a Tip Protector Bolt (m) through both Brackets and into a Stop
Nut (n). Tighten the Stop Nut with a crescent wrench until secure. See the Detailed View of Diagram 15 for assistance.
Note: Diagram 15 is a cutaway view. Diagram 15
Detailed View
aa m
bb
n