Filter
Top Products
CLEANING AND STORAGE
23
TRANSPORTING
• Allow the engine to cool before transporting.
• Secure the unit while transporting.
• Drain fuel from unit.
• Tighten fuel cap before transporting.
CLEANING
WARNING: To avoid serious
personal injury, always turn your
trimmer off and allow it to cool
before you clean or do any
maintenance on it.
Use a small brush to clean off the outside of the
unit. Do not use strong detergents. Household
cleaners that contain aromatic oils such as pine
and lemon, and solvents such as kerosene, can
damage plastic housing or handle. Wipe off any
moisture with a soft cloth.
STORAGE
• Never store the unit with fuel in the tank
where fumes may reach an open flame or
spark.
• Allow the engine to cool before storing.
• Store the unit locked up to prevent
unauthorized use or damage.
• Store the unit in a dry, well ventilated area.
• Store the unit out of the reach of children.
LONG TERM STORAGE
If the unit will be stored for an extended time,
use the following storage procedure.
1. Drain all fuel from the fuel tank and drain into
a container with the same 2-cycle fuel
mixture. Do not use fuel that has been stored
for more than 60 days. Dispose of the old
fuel/oil mix in accordance to Federal, State,
and Local regulations.
2. Start the engine and allow it to run until it
stalls. This ensures that all fuel has been
drained from the carburetor.
3. Allow the engine to cool. Remove the spark
plug and put 1 oz. (30 ml.) of any high quality
motor oil or 2-cycle oil into the cylinder. Pull
the starter rope slowly to distribute the oil.
Reinstall the spark plug.
NOTE: Remove the spark plug and drain all
of the oil from the cylinder before
attempting to start the trimmer after
storage.
4. Thoroughly clean the unit and inspect for any
loose or damaged parts. Repair or replace
damaged parts and tighten loose screws,
nuts or bolts. The unit is ready for storage.