Filter
Top Products
MAINTENANCE AND REPAIR INSTRUCTIONS
18
Bump Knob
Foam Seal
Spring
Inner Reel
Installing a Prewound Inner reel
1. Remove the bump knob, spring, and foam
seal by turning the Bump Knob
counterclockwise (Fig. 26).
9. If winding the line becomes difficult or the
line jams, pull the ends of the line from the
spool (Fig. 25). Continue winding the inner
reel counterclockwise .
4. Hold the inner reel in place and install the
bump knob, spring and foam seal by
pressing down and turning the bump knob
clockwise. Grasp the ends and pull firmly to
release the line from the holding slots in the
inner reel. (Fig. 25).
Releasing the Inner Reel
If the SpeedSpool
®
does not release line
correctly, pull the ends of the line firmly from
the spool (Fig. 25). If this does not release line,
follow the Cleaning the SpeedSpool
®
instructions below.
Cleaning the SpeedSpool
®
Cleaning the SpeedSpool
®
may be necessary,
• To remove jammed or excess line,
• If the SpeedSpool
®
becomes difficult to wind
or does not operate correctly when bumping
the head on the ground,
1. Hold the outer spool, and unscrew the bump
knob counterclockwise (Fig. 28).
2. Pull out the bump knob, spring, and foam
seal (Fig. 26).
Fig. 28
Fig. 27
Fig. 25
Fig. 24
Fig. 26
2. Pull the old inner reel with existing line from
the outer spool.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4)
inches (102 mm.) of line remain (Fig. 24).
NOTE: Do not wind the inner reel before
installing the second piece of line.
3. Insert the ends the of line into the outer
spool eyelets (Fig. 27). Push the new inner
reel, arrow side up, into the outer spool.