Filter
Top Products
OPERATING INSTRUCTIONS
14
2. While firmly holding the add-on, push it
straight into the Click-Link
®
coupler (Fig. 14).
NOTE: Aligning the release button with the
guide recess will help installation
(Fig. 14).
3. Turn the knob clockwise to tighten
(Fig. 15).
CAUTION: Lock the release button
in the primary hole and securely
tighten the knob before operating
this unit.
OPERATING THE CLICK-LINK
®
SYSTEM - MODEL 775r
The model 775r Click-Link
®
system enables the
use of these optional add-ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedgetrimmer . . . . . . . . . . . . . . . . . . . HS720r
Snowthrower . . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . SS725r
Sweeper/Blower . . . . . . . . . . . . . . . . . . SB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . TB720r
WARNING: Read and understand
operator’s manual for add-on prior to
operation.
Removing the Cutting Attachment
or Add-Ons:
1. Turn the knob counterclockwise to loosen
(Fig. 13).
2. Press and hold the release button (Fig. 13).
3. While firmly holding the upper shaft housing,
pull the cutting attachment or add-on
straight out of the Click-Link
®
coupler.
Installing the Cutting Attachment or
Add-Ons:
WARNING: To avoid serious
personal injury, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the
add-on easier, place the unit on the
ground or on a work bench.
1. Turn the knob counterclockwise to loosen
(Fig. 13).
Click-Link
®
Coupler
Release Button
Guide Recess
Knob
Primary Hole
Upper Shaft Housing
Lower Shaft Housing
Release Button
90˚ Edging Hole
180˚ Edging Hole
Knob
Fig. 13
Fig. 14
Fig. 15
Click-Link
®
Coupler
CAUTION:
The cutting attachment
and add-ons with the Click-Link
®
system are to be used in the primary
hole unless stated otherwise in the
specific add-ons operator’s manual.
Using the wrong hole could lead to
personal injury, or damage to the
unit.
For edging with Click-Link
®
models, lock the
release button of the cutting attachment into the
90° edging hole or the 180° edging hole
(Fig. 15).