Filter
Top Products
18
Regular maintenance will improve the performance and
extend life of the generator. See any authorized dealer for
service.
NOTICE Once a year you should replace the spark plugs and
air filter. A new spark plug and clean air filter assure proper
fuel-air mixture and help your engine run better and last
longer.
Emissions Control
Maintenance, replacement, or repair of the emissions
control devices and systems may be performed by any non-
road engine repair establishment or individual.
However, to obtain “no charge” emissions control service,
the work must be performed by a factory authorized dealer.
See the Emission Warranty.
Generator Maintenance
The generator warranty does not cover items that have been
subjected to operator abuse or negligence. To receive full
value from the warranty, the operator must maintain the
generator as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your generator.
All service and adjustments should be made at least once
each season. Follow the requirements in the Maintenance
Schedule chart.
When all engine servicing is complete, replace 15 Amp fuse
in control panel and reset the exercise timer. See Setting
Exercise Time in Operation.
High Temperature (FC_7)
This fault is indicated by fault code FC_7 and seven blinks on
the remote LED indicator. The contacts of the temperature
switch are normally open. If the engine temperature exceeds
approximately 149°C (300°F), the fault is detected and the
engine shuts down.
Common causes for this condition include running the
unit with access doors removed, obstructed air inlet or
exhaust port, low oil level, or debris in the engine cylinder
cooling fins.
To resolve the problem, let the engine cool down and remove
any accumulated debris and obstructions. Ensure that all
access doors are installed whenever the unit is running.
Transfer Switch Fault (FC_8)
This fault is indicated by fault code FC_8 and eight blinks on
the remote LED indicator (if transfer switch is equipped with
faultdetection).
The most likely cause of this fault is a blown fuse in the
transfer switch. To remedy the problem, contact your installer
or an authorized dealer.
Maintenance Schedule
Follow the hourly or calendar intervals of operation,
whichever occurs first.
First 5 Hours
Change Engine Oil
Every 8 Hours or Daily
Clean Debris
Check Engine Oil Level
Every 100 Hours or Annually
Change Air Filter
Change Engine Oil and Filter
Replace Spark Plugs
Check Valve Clearance
Annually
Clean Air Cooling System
Check Fuel System
Check Exhaust System
Test System Operation (Simulate a Power Outage)
NOT
FOR
REPRODUCTION
r maintenancmaintenan
end life of thend life of t
ervice.ervice.
NOTICENOTICE
EE
air filteair fi
fuefue
rvicing is comvicing is c
and reset theand reset the
ee
in in
ee
OperatioOperatio
ON
imulatemulate