Filter
Top Products
LOOSE PARTS KIT
DESCRIPTION
Steering wheel
Roll Pin
Stone Guard Assy.
Spring Stone Guard
‘E’ Clip
Ignition Keys
Plug Spanner
QTY
1
1
1
1
1
1
1
USE
On steering shaft
Secure steering wheel to shaft
Fitted to cutter head
On stone guard pivot rod
In groove in pivot rod
To start machine
SETTING UP INSTRUCTIONS
Fig. 2
INSTALL STEERING WHEEL
1. Slip steering wheel over steering shaft and align the wheel
hole with the shaft hole;
2. Insert drift punch – partially through the holes to maintain
alignment and insert roll pin in the opposite side; See
Fig.2.
3. Drive roll pin in until flush with the outside of wheel.
Fig. 3
FIT STONE GUARD
1. Slip spring into stone guard pivot rod so that the short leg
rests on top of the stone guard;
2. Now twist the spring as shown and feed the end of the
pivot rod into the forward pivot bracket: See Fig.3.
3. Insert the short end of the pivot rod fully into the rearward
pivot bracket;
4. Release the spring. It should spring down onto the top of
the cutter head and be tensioning the stone guard down;
Fig. 4
5. Secure by clipping an ‘E’ Clip into the groove on the pivot
rod. See Fig. 4.
INSTALLING THE BATTERY
BATTERY
1. Remove Battery as follows;
(a). remove terminal cable from battery;
(b). undo wingnuts and remove clamp bar.
2. The battery is not filled with Electrolyte. This should be
done by adding 33% strength battery acid to each cell
until plates are covered. Electrolyte must be purchased
from a local battery supply outlet.
IMPORTANT: DO NOT OVERFILL BATTERY. ACID WILL
OVERFLOW INTO OTHER PARTS OF THE MACHINE AND
SEVERE CORROSION AND DETERIORATION WILL RESULT.
3. Leave filler caps off and connect battery charger to
battery terminal. Charge at the rate indicated in the
instructions supplied with the battery.
4. After charging, check that Electrolyte is still covering
plates, if not, add to correct level. Install filler caps.
5. Replace battery and secure.
6. Install the positive (red) cable to the positive (+)
terminal and the negative (black) cable to the negative
(-) terminal.
Secure for good electrical contact.
3