Filter
Top Products
8-2-4
MAIN
SYSTEM
1)
Remove the bolt
(20)
and take out float chamber body
(18).
2)
Remove the main jet
(2
1) from. the body
(
14)
D
3)
Reassembly
a) Fasten the main jet securely
to
the body. Otherwise, the fuel may become too rich and cause engine
b) The bolt tightening torque is
70
kg-cm.
malfunction.
8-2-5
FLOAT SYSTEM
1)
Pull out the float
pin
(1
7)
and
remove the float
(1
6)
and needle valve
(25).
If
the needle valve need be re-
placed, replace it with rubber needle.
Caution: When cleaning the jets, use neither a drill nor a wire (because
of
possible damage
of
the orifice
2)
When removing the needle
valve
and
flots,
gently tap the reverse side using the rod more slender than the
which will adversely affect fuel flow). Be sure
to
use compressed air
to
blow
them clean.
float
pin
and remove because the float
pin
is
calked to the carburetor body.
-35
-