Filter
Top Products
118035
Figure 4-2: Plugging extension cord into inlet plug,
Model ST3812B
Safety Warnings
Use proper extension cord with this tool.
Use only a polarized (i.e., one blade is
wider than the other), UL listed exten-
sion cord marked for outdoor use. e
cord must be marked with suffix W or
W-A following the cord type designation.
Example: SJTW-A or SJTW.
Use proper sized cord with this tool. Cord
must be heavy enough to carry current
needed. An undersized cord will cause volt-
age drop at trimmer/edger. e trimmer/
edger will lose power and overheat. Follow
cord size requirements listed below.
Inspect cord often. Replace if damaged.
e trimmer/edger has a built-in extension
cord retainer. is cord hitch prevents ac-
cidental disconnection of the power cord
during use. e cord hitch is molded into
the rear handle.
1a. Model ST4514B: Plug power cord
into extension cord (see Figure 4-1).
1b.
Model ST3812B: Plug extension cord
into inlet plug of tool (see Figure 4-2).
2. Create a loop in the extension cord
and insert through the bottom of the
tool housing (see Figure 4-3).
3. Pull the loop tight around the molded
cord hitch (see Figure 4-4).
Note: For Model ST4514B, an optional
method of retaining the extension cord
is shown in Figure 4-5. Use this method
with larger-gauge cords that may not fit
into the extension cord retainer.
Figure 4-1: Plugging extension cord into power cord,
Model ST4514B
Figure 4-4: Pull extension cord loop tight around molded
cord hitch
Figure 4-5: Optional method of retaining extension cord
Figure 4-3: Inserting extension cord loop through bottom
of handle
25 feet
50 feet
100 feet
150 feet
18 AWG
16 AWG
16 AWG
14 AWG