Filter
Top Products
7
104673
OWNER’S MANUAL
TRIMMING A TREE (Pruning)
WARNING: Avoid kickback.
Kickback can result in severe in-
jury or death. See
Kickback
, page
3, to avoid risk of kickback.
WARNING: Do not operate
Pole Saw while in a tree, on a
ladder or any other unstable work
surface, or in any awkward posi-
tion. You may lose control of Pole
Saw causing severe injury.
WARNING: Do not extend
arms above shoulders when us-
ing Pole Saw.
CAUTION: Seek professional
help if facing conditions beyond
your ability.
Trimming a tree is the process of cutting
limbs from a living tree. Make sure footing
is firm. Keep feet apart. Divide your weight
evenly on both feet.
1. Make first cut six inches from tree trunk
on underside of limb. Use top of guide
bar to make this cut. (Cut 1/3 through
diameter of limb, see figure 11).
2. Move two to four inches farther out on
limb. Make second cut from above limb.
Continue cut until you cut limb off.
3. Make third cut as close to tree trunk as
possible on underside of limb stub. Use
top of guide bar to make this cut. Cut
1/3 through diameter of stub.
4. Make fourth cut directly above third
cut. Cut down to meet third cut. This
will remove limb stub.
OPERATING POLE
SAW
Continued
Figure 11 - Cutting A Limb
2" to 4"
6"
1st Cut -
Pruning Undercut
(to avoid splintering)
3rd Cut - Stub Undercut
(to avoid splintering)
2nd Cut -
Pruning Cut
(to avoid pinching)
4th Cut -
Final Stub Cut