Filter
Top Products
46
Change the loop handle to the J-handle for safe
operation. (OP4)
(1) Bracket : 3583-14101
(2) J-handle : 6367-14200
■ STARTING THE ENGINE
Please refer 5.For safe operation (P.14), 8.Operation
(P.36).
•The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment could
rotate as soon as the engine is started. When
starting the engine, place the product onto the
ground in a flat clear area and hold it firmly in
place so as to ensure that neither the cutting
part nor the throttle come into contact with any
obstacle when the engine starts. (OP5)
■ CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left with it tilted
slightly to your left. (OP6)
c) When mowing a wide area, start working from your
left end to avoid interference of cut grass.
d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting depth
according to the condition of object.
• If the grass or other object gets caught in the
blade, or if the unit starts to shake or vibrate,
turn off the engine and check the whole unit.
Change the blade if it has been damaged.
• Turn off the engine and make sure the blade has
completely stop before checking the blade, and
removing any object got caught in.
WARNING
WARNING
IMPORTANT
BC-EX2
OP4
BC-EX2
OP6
BC-EX2
OP5
BC-EX2
OP7
8. Operation (BC-EX2 only)
(Optional blade usage)
English