Filter
Top Products
26
PS-EX
SE5
PS-EX
SE6
4. Adjust the chain tension by turning the tensioner
screw until the tie straps just touch the bottom side
of the bar rail. (SE5)
(1) Chain tension adjusting screw
(a) Loosen
(b) Tighten
5. Tighten the mounting nut securely with the bar tip
held up (TORQUE: 8.9~11.7 N.m./90~120 kg-cm).
Then check the chain for smooth rotation and correct
tension while moving it by hand. If necessary,
readjustment. (SE6)
(1) Tighten
It is very important to maintain the proper chain
tension. Rapid wear of the guide bar or the chain
coming off easily can be caused by improper
tension. Especially when using a new chain, take
good care of it since it should expand when first
used.
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or
down until unit balances and the strap fits your body.
WARNING
6. Set up (PS-EX only)
English
6. Set up (HE-EX2 only)
1. Attach the gearbox to the shaft tube as aligning the
positioning holes and fasten the screw (A). Fasten
the clamp bolt (B) firmly. (SE1)
(A) Screw
(B) Clamp bolt
(B) Tightning Torque: 70~130 in-lb (8~15 N.m)
(B)
(A)
HE-EX2
SE1