Filter
Top Products
8
Receiving
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Rip Saw
is installed and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of crate:
1 Rip saw body
1 Rip fence
1 Blade
1 Toolbox containing (shown in Figure 2):
A – 1 grease gun
B – 1 set open-end wrenches
C – 1 set hex wrenches
D – 4 cast iron foot pads
E – 4 M16x80 leveling screws
E – 4 M16 hex nuts
F – 1 arbor wrench
G – 1 T-wrench
1 Instruction manual
1 Warranty card
Installation
Tools required for assembly:
forklift or hoist, with slings
open-end wrenches (provided)
hex wrenches (provided)
arbor wrench (provided)
T-wrench (provided)
NOTE: The terms “front”, “back”, “infeed side”
and “outfeed side” are explained on page 7.
1. Lift the machine with a hoist or forklift, using
slings through the lifting eyes on the
machine. Make sure the capacity of the
lifting unit is sufficient to lift this size
machine.
2. The rip saw should be located in an area
that is well-lit, with a sturdy, level floor and
enough space for loading and off-loading
stock and general servicing of the machine.
3. The rip saw can be bolted to the floor
through the holes at the four corners. If it will
not be bolted to the floor, the four cast iron
foot pads should be placed beneath the
corners, with the four M16 x 80 leveling
screws and four M16 nuts. See Figure 3.
Figure 2
Figure 3