Filter
Top Products
3
WARNING: The blade continues to
spin after throttle is released or engine is
turned off. The coasting blade can throw ob-
jects or seriously cut you if accidentally
touched. Stop the blade by contacting the left
hand side of coasting blade with m aterial al-
ready cut.
Stop coasting
blade by contact
with cut material.
OPERATOR SAFET Y
S Dressproperly. Alwayswearsafetyglasses
or similar eye protection when operating, or
performing maintenance on your unit (safe-
ty glasses are available). Eye protection
should be marked Z87.
S Always wear face or dust mask if operation
is dusty.
S Always wear heavy, long pants, long
sleeves, boots, and gloves. Wearing safety
leg guards is recommended.
S Always wear foot protection. Do not go
barefootor wearsandals.Stay clearofspin-
ning line/blade.
S Secure hair above shoulder length. Secure or
remove loose clothing and jewelry or clothing
with loosely hanging ties, straps, t assels, etc.
They can be caught in moving parts.
S Being fully covered also helps protect you
from debris and pieces of toxic plants
thrown by spinning line/blade.
S Stay alert.Donot operate unitwhen youare
tired, ill,upset orunder influence ofalcohol,
drugs, or medication. Watch what you are
doing; use common sense.
S Wear hearing protection.
S Never start o r run the engine inside a closed
room or building. Breathing exhaust fumes
can kill.
S Keep handles free of oil and fuel.
S Always use the handlebar and a properly
adjusted shoulder strap when using brush-
cutter attachment (see ASSEMBLY).
UNIT/MAINTENANCE SAFETY
WARNING: Disconnect powerhead
spark plug (or disconnect powerhead from pow-
er source) before performing maintenance.
S Look for and replace damaged or loose
parts before each use. Look for and repair
fuel leaks before use. Keep unit in good
working condition.
S Throw away blades that are bent, warped,
cracked, broken, or damaged in any other
way. Replace trimmer head parts that are
cracked, chipped, broken, or damaged in
any other way before using the unit.
S Maintain the unit according t o r ecommended
procedures. Keep the blade sharp. Never use
flailing devices, wire, rope, string, etc.
S Use only specified blade; make sure it is
properly installed and securely fastened.
S Never start engine with clutch shroud re-
moved. The clutch can fly offand cause se-
rious injury.
S Be sure blade stops turning when engine
idles.
S Makecarburetoradjustments withthelower
end supported to prevent the blade from
contactinganyobject.Holdtheunit byhand;
do not use the shoulder strap for support.
S Keep others away when making carburetor
adjustments.
S Use only recommended Poulan PRO® ac-
cessories and replacement parts.
S Have all maintenance and service not ex-
plained in this manual performed by an au-
thorized service dealer.
FUEL SAFETY
S Mix and pour fuel outdoors.
S Keep away from sparks or flames.
S Use a container approved for fuel.
S Do not smoke or allow smoking near fuel or
the unit or while using the unit.
S A void spilling fuel or oil. Wipe up all fuel
spills before starting engine.
S Move at least 10 f eet (3 meters) away fromfu-
eling site before starting engine.
S Stop engine and allow it to cool befor e re-
moving fuel cap.
S Remove fuel cap slowly.
CUTTING SAFETY
WARNING: Inspect the area to becut
beforeeachuse.Remove objects(rocks,bro-
ken glass, nails, wire, string, etc.) which can
bethrownor becomeentangledinthebladeor
trimmer line.
S Keepothers including children,animals,by-
standers, and helpers at least 50 feet (15
meters) away. Stop the engineimmediately
if you are approached.
S Always keep engine on the right--hand side
of your body.
S Hold the unit firmly with both hands.
S Keep firmfooting and balance. Do notover-
reach.
S Keep blade/trimmer hea dbelow waistlevel.
S Do not raise powerhead engine above your
wai st.
S Keep allparts of your body away from spin-
ning line/blade and muf fler.
S Cut from your left to your right. Cutting on
the right side of the shield will throw debris
away from the operator .
S Use only in daylight or good artificial light.
S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
S Stop thepowerhead engine before carrying
unit.
S Keep muffler away from your body.
S Allow engine to cool and secure unit before
storing or transporting it in a vehicle.
S Empty the fuel tank before storing or trans-
portingthe unit.Use upfuel leftin thecarbu-
retor by starting the engine andletting it run
until it stops.
S Store unitand fuel in an area where fuel va-
pors cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.