Filter
Top Products
9
WARNING: Make sure the locking/
release button is locked in the prim ary hole
and the knob is securely tightened before op-
erating the unit. Usin g t he wrong hole cou ld
lead to serious injury or damage to the unit.
Locking/Release
Button in Primary Hole
BAR AND CHAIN LUBRICAT ION
The bar and chain require lubrication. The
chain oiler provides continuous lubrication to
the chain and guide bar. Be sure to fill the bar
oil tank before use (Capacity = 4.6 fl. oz.).
Lack of oil will quickly ruin the bar and chain.
Too little oil will cause overheating shown by
smokecomingfromthechain and/ordiscolor-
ationof thebar. Theoiloutput isautomatically
metered during operation.
Genuine Poulan or Poulan PRO bar and
chain oil is recommended to protect your unit
against excessive wear from heat and fric-
tion. Poulan or Poulan PRO oil resists high
temperature thinning. If Poulan or Poulan
PRO bar andchain oilis not available, use a
good grade SAE 30 oil.
S Never use waste oil for bar and chain lubri-
cation.
S Always stop the engine before removing
the oil cap.
INSTAL L ING ATTACH MEN T
HANGER
An attachment hanger is provided for storage
when attachment is not in use.
To install hanger on attachment:
1. Rem ovetheshaft capfromtheattachment
(if present) and discard.
2. P ress andhold the locking/releasebutton.
3. P ush hanger onto the attachment until the
locking/release buttonsnaps intothe hole.
OPERATING POSITION
Eye
Protection
ALWAYS WEAR:
Long Pants
Heavy Shoes
Head
Protection
DANGER: Do notextend armsabove
shoulders while pruning. Do not stand be-
neath branch being cut.
WARNING: Always wear head, eye,
hearing, foot and body protection to reduce
the risk of injury when operating this unit.
When operating unit, clip shoulder strap onto
clamp, stand as shown and check for the fol-
lowing:
S Extend your leftarmand hold assisthandle
with your left hand.
S Hold throttle grip with your right hand with
finger on throttle trigger.
S Keep engine end below waist level.
S Keep shoulder strap pad centered on your
left shoulder and danger sign centered on
your ba ck.
S Maintain full weight of tool on your left
shoulder.
PRUNING
WARNING: Be alert for and guard
against kickback. Do not allowthe movingchain
to contact any other branches or objects at the
nose of the guide bar when pruning. Allowing
such contact can result in serious injury.
IMPORTAN T POINTS
S Work slowly , keeping both hands firmly
grippedonthe p runer.Maintain securefoot-
ing and balance.
S Plan cut carefully. Check direction branch
will fall.
S Watch out for springpoles. Springpoles are
small size limbs which can catch the chain
and whip toward you or pull you off b alance.
Use extreme caution when cutting small size
limbs or slender material.
S Watch out for branches immediately b ehind
the branch being pruned. If the chain hits the
rear branch, damage to the unit may occur .
S Be alert for springback. Watch out for
branches that are bent or under pressure.
Avoid being struck by the branch or the
pruner when the tension in the wood fibers
is released.
S Keep a clear work area. Frequently clear
branches out of the way to avoid tripping
over them .
S Long branches should be removed in sev-
eral pieces.
PRUNING TECHNIQUE
When ready to cut, accelerate to full throttle
and apply a light cutting pressure. DO NOT
use back and forth sawing action.