Filter
Top Products
7
HELPFUL TIP
If your engineswitchreads
“push to stop”, it is always
in the ON position.
HOW TO STOP Y OUR UNIT
S To stop the engine, push and hold the STOP
switch in the STOP position until the engine
stops.
S If engine does not stop, move choke lever
to FULL CHOKE position.
HOW TO START YOUR UN IT
WARNING: The trimmer head will
turnwhilestarting theengine. A voidanycon-
tact with the muffler. A hot muf fler can cause
serious burns.
HELPFUL TIP
If your engine still does not
start after following these
instructions, please call
1--800--554--6723.
STARTING A C OLD ENGI NE (or a
warm engine after running out of
fuel)
Starting Position
1. Setunitonaflatsurface.
2. Slowly press the primer bulb 6 times.
3. Move choke lever to t he F ULL CHOKE
position.
4. Squeeze t he throttle trigger fully and hold
through all remaining steps.
Choke
Lever
Starter Handle
Primer Bulb
5. Pull starterrope handlesharply untilengine
sounds as if it is trying to start, but do not
pull rope more than 6 times.
6. As soonas enginesounds asifitis tryingto
start, move choke lever to HALF CHOKE
position.
7. Pull starter rope sharply until engine runs,
but no more than 6 pulls.
NOTE:Ifthe eng inedoesn’tstart after6
pulls (at the HALF CHOKE position),
move the choke lever to the FULL
CHOKE position and press the primer
bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE positionandpullthestart-
errope untiltheengineruns,butnomore
than 6 pulls. I f the engine still doesn’t
start, it is probably flooded. Proceed to
STARTING A FLOODED ENGINE.
8. Oncetheenginestarts,allowit t orun10se-
con d s, the n mo ve th e c hoke le ve r to th e
RUN position. Allow the u nit to run f or 30
more seconds at RUN beforereleasingthe
throttle trigger .
NOTE: If engine dies with the choke le-
ver in theRUN position, move thechoke
lever to the HALF CHOKE position and
pull the rope until engine runs, but no
more than 6 pulls.
STARTING A WARM ENGINE
1. M ove the choke lever to the HALF
CHOKE position.
2. Squeeze and hold the throttle trigger .
Keep throttle trigger fully squeezed until
the engine runs smoothly.
3. Pull starter rope sharply until engine runs,
but no more than 6 pulls.
4. Allow engine to run 15 seconds, then
move the choke lever t o the RUN posi-
tion.
NOTE:If engine has notstarted, pull starter
rope5 m orepulls. Ifengine stilldoes notrun,
it is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can b e started by placing
thechokeleverintheRUNposition;then,pull
the rope to clear the engine of excess fuel.
This could require pulling the starter handle
many times dependingon how badly theunit
is flooded.Iftheunit still doesn’tstart, referto
TROUBLESHOOTING TABLE or call
1-800-554--6723.
OPERATING INSTRUCTIONS
It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.