Filter
Top Products
-- 9 --
NOTE:
Do notattempt to clean the spark ar-
resting screen.
1. Loosen and remove the 2screws from the
muffler cover. Remove the muffler cover.
2. Loosen and remove both screws from the
exhaust diverter.
3. Remove the exhaust diverter and spark
arresting screen.
4 Install new spark arresting screen.
5. Reinstall exhaust diverter and both
screws. Tighten screws securely.
6. Reinstall muffler cover and 2 screws.
Tighten securely.
NOTE:
If any part of the muffler is cracked,
broken or damaged, we recommend that the
muffler be replaced.
CARBURETOR ADJUSTMENTS
There is no screw for idle adjustment onyour
blower. The t hrottle lever is used to control
engine speed. The throttle lever can be
placed in one of four positions: STOP, IDLE
or
, FULL THROTTLE or , and one
intermittent position. If yourengine will not run
properly or you require further assistance,
contact an aut horized service dealer or call
1--800--554--6723.
STORAGE
WARNING:
Perform the following
steps after each use:
S
Allow engine to cool, and secure the unit
before storing or transporting.
S
Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
S
Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
S
Store unit and fuel well out of the reach of
children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.If your
unit is to be stored for a period of time:
S
Clean the entire unit before lengthy stor-
age.
S
Store in a clean dry area.
S
Lightly oil external metal surfaces.
FUEL SYSTEM
Under FUELING ENGINE in the OPERA-
TION section of this manual, seemessage la-
beled IMPORTANT regarding the use of ga-
sohol in your engine.
Fuel stabilizer is an accep tab le alternativ e in
minimizing the formation of fuel gum deposi ts
during storage. Add stabilizer to gasoline in fuel
tank or fuel stor age container. Follow the mix
instructions found on stabilizer c ontainer. Run
engine at least 5 minutes after adding stabilizer.
ENGINE
S
Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.
S
Replace spark plug with newone of recom-
mended type and heat range.
S
Clean air filter.
S
Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.
S
At the beginning of the next season, use
only fresh fuel having theproper gasoline to
oil ratio.
OTHER
S
Do not store gasoline from one season to
another.
S
Replace yourgasoline can if itstarts torust.