Filter
Top Products
-- 1 0 --
TROUBLE
CAUSE REMEDY
Engine will not
start.
1. Engine flooded.
2. Fuel tank empty.
3. Spark plug not firing.
4. Fuel not reaching
carburetor.
5. Compression low.
1. See “Starting a Flooded Engine”
in Operation s ection.
2. Fill tank with correct fuel mixture.
3. Install new spark plug.
4. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
5. Contact an authorized serv ice dealer.
Engine will not
idle properly.
1. Fuel not reaching
carburetor.
2. Carburetor requires
adjustment.
3. Crankshaft seals worn.
4. Compression low.
1. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
2. Contact an authorized serv ice dealer.
3. Contact an authorized serv ice dealer
4. Contact an authorized serv ice dealer.
1. Air filter dirty.
2. Fuel not reaching
carburetor.
3. Spark plug fouled.
4. Carburetor requires
adjustment.
5. Carbon build up.
6. Compression low.
Engine will not
accelerate,
lacks power, or
dies under a
load.
1. Clean or replace air filter.
2. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
3. Clean or replace spark plug
and re-gap.
4. Contact an authorized serv ice dealer.
5. Contact an authorized serv ice dealer.
6. Contact an authorized serv ice dealer.
Engine smokes
excessively .
1. Choke partially on.
2. Fuel mixture incorrect.
3. Air filter dirty.
4. Carburetor requires
adjustment.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. Contact an authorized serv ice dealer.
Engine runs hot.
1. Fuel mixture incorrect.
2. Spark plug incorrect.
3. Carburetor requires
adjustment.
4. Carbon build up.
1. See “Fueling Engine” in Operation
section.
2. Replace with correct spark plug.
3. Contact an authorized serv ice dealer.
4. Contact an authorized serv ice dealer.
TROUBLESHOOTING TABLE
WARNING:
Always stopunit anddisconnect spark plug befor e perfor ming anyof the
recomm ended r emedies below other than rem edies that require oper ation of the unit.