Filter
Top Products
7
OPERATION
KNOW YOUR BRUSHCUTTER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT.
Compare the illustr atio n s with your unit to familia rize yours elf with the loc a tion of the various contro ls
and adjustments. Save this manual for future reference.
Line Limiter
Blade
Shield
Trimmer Head
Tube
Handlebar
ON/STOP Switch
Primer Bulb
Muffler
Throttle
Trigger
Choke Lev er
Starter Handle
Blade
ON/STOP SWITCH
The ON /STO P switch is used to stop the
engine. To stop t he engine, push and release
the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the s tarter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
CHOKE
The CHO KE helps to supply f uel to the engine
to aid i n cold star tin g . Activate the choke by
moving the choke lever t o the F ULL CH O KE
position. After the engine attempts to start, move
the c hoke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the OFF CHOKE position.
BEFORE STARTING ENGINE
WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. If you do not understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
WARNING:
Remove fuel cap slowly
when refueling.
This engine is certified to operate on un-
leaded gasoline. Before operation, gasoline
must be mixed with a good quality synthetic
2-cycle air-cooled engine oil designed to be
mixed at a ratio of 40:1. Poulan/Weed Eater
brand synthetic oil is recomm ended. Mix gaso-
line and oil at a ratio of 40:1. A 40:1 ratio is ob-
tained by mixing 3.2 ounces of oil with 1 gallon
of unleaded gasoline.
DO NOT USE automotive oil or boat oil.
These oils will c ause engine damage. When
mixing fuel, follow instructions printed on con-
tainer. Once oil is added to gasoline, shake
container momentarily to assure that the fuel
is thoroughly mixed. Always read and follow
the safety rules relating to fuel before fueling
your unit.
IMPORTANT
Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to
separation and formation of acids during stor-
age. Acidic gas can damage the fuel system
of an engine while in storage.
To avoid engine problems, empty the fuel sys-
tem before storage for 30 days or longer.
Drain the gas tank, start the engine and let it
run until the fuel lines and carburetor are
empty. Use fresh fuel next season.
Never use engine or carburetor cleaner prod-
ucts in the fuel tank or permanent damage
may occur.
See the STORAGE section for additional in-
formation.
HOW TO STOP YOUR UNIT
S
To stop the engine, push and release the
engine ON/STOP switch. The switch will
automatically return to the O N position.
Wait 5 seconds before attempting to restart
unit to allow switch to reset.
S
If engine does not stop, m ove choke lever
to FULL CHOK E position.