Filter
Top Products
7
S
Install the blade nut by threading onto the
shaft counterclockwise.
Shield
Blade
Retaining
Washer
Dust Cup
Cupped
Washer
Nut
Threaded
Shaft
WARNING:
Donot use any blades, or
fastening hardw ar e other than the
was h e rs and nuts illus trated. These parts must
be pr ovided by POULAN PRO , and installed as
shown below. Failure t o use proper par ts can
cause the blade to fly off and seriously hur t you
or others.
NOTE:
Make sure all parts are in place as il-
lustrated, and the blade is sandwiched be-
tween the dust cup and the retaining washer.
There should be no space between t he blade
and the dust cup or the retaining washer.
S
Align hole inthe dust cup with the hole inthe
side of the gearbox by rotating the blade.
S
Insert a hex wrench into the aligned holes.
This will keep the shaft from turning while
tightening the blade nut.
Hex Wrench
S
Tighten the blade nut firmly with a wrench
while holding hex wrench in position.
S
Remove the hex wrench.
S
Turn blade by hand. If the blade binds
against the shield, or appears to beuneven,
the blade is not centered, andyou must rein-
stall.
NOTE:
To remove blade, insert hex wrench
into aligned holes. Un-thread nut and remove
parts. Be sure to store parts and instructions
for future use.
FUEL YOUR UNIT
This engine i s certified t o operate on unleaded
gasoline. Gasoline must be mixed with a good
quality 2- cycle air- cooled engine oil designed to
be mixed at a ratio of 40:1. Poulan/W eed Eater
brand oil is recommended. (A 40:1 ratio is ob-
tained by mixing 3.2ounces of oilwith 1 gallonof
unleaded gasoline). When mixing fuel follow the
instructions printed on the container. Always
read and follow the safety rules under FU EL
SAFETY.
STARTING
HOW TO STOP YOUR UNIT
S
Move the ON/STOP switch to the STOP
position (toward the cutting head).
S
If engine does not stop, move choke to the
FULL CHOKE position.
Throttle Trigger
ON/STOP
Switch
ON
STOP
STARTING YOUR ENGINE
WARNING:
The blade or trimmer
head will turn while starting the engine. Avoid
any contact with the muffler. A hot muffler can
cause serious burns.
NOTE:
A special feature called the “Throttle
Lock” holds the throttle tr igger in the depressed
position dur ing starting.
S
Lock throttle trigger into the starting postion
by first pressing the lockout lever on the top
ofthe control handle. While the lockout lever
is depressed, squeeze and hold the throttle
trigger.
Throttle Trigger
Lockout
Lever
Lock Button
S
Before releasing the throttle trigger, press
the lock button. While this button is still de-
pressed release the throttle trigger.
NOTE:
This should allow the throttle trigger
to remain in the depressed position for start-
ing. You may want to practice this a few times
before you first start the unit.
S
DO NOT squeeze throttle trigger during
starting; otherwise, it will be necessary to
reset the throttle lock.
COLD ENGINE OR WARM ENGINE
AFTER RUNNING OUT OF FUEL
S
Rest engine and shield on ground, support-
ing trimmer head off ground.
S
Move the switch to the ON position.
S
Slowly press the primer bulb 6 times.
S
Move the choke lever to FULL CHOKE
position.