Filter
Top Products
31
OPERATION
Safe Operating Precautions
AC Operation
Before connecting a device or power cord to the generator, ensure it is in
good condition. Faulty appliances or power cords can create a potential
for electrical shock.
If an appliance begins to operate abnormally, becomes sluggish, or
suddenly stops, immediately shut it off. Disconnect the appliance and
determine whether the problem is the appliance or if the rated load
capacity of the generator has been exceeded.
Ensure the combined electrical rating of the device or appliance does not
exceed the maximum allowed by the generator. Never exceed the
maximum power rating of the generator. Power levels between rated and
maximum may be used for no more than 30 minutes.
Note: When the electric motor starts, the overload indicator (middle light) may
illuminate (RED) and extinguish within 4 seconds. If the overload indicator
remains illuminated, consult the generator supplier.
Note: In order to insure the optimum output and the maximum service life of the
generator, the generator should run at a 50% load for the first 20 hours
1. Start the engine and ensure that
the output indicator (A)
illuminates (GREEN).
2. Plug the device or extension cord
into one of the AC receptacles
(B).
3. Turn on the device.
Note: If the generator is overloaded or if
there is a short circuit in a
connected appliance, the overload
indicator (RED) will illuminate. The
overload indicator will remain
illuminated and, after about 4
seconds, current to the connected
appliance(s) will shut off but the
engine will stay running. The output
indicator (GREEN) will extinguish.
4. If overloaded or short circuit in a connected device occurs, stop the
engine and refer to the “Troubleshooting” section. Determine if the
cause is a short circuit in the connected device or an overload.
Correct the problem and restart the generator.
5. After determining the cause of the overload and when it is safe to
resume using the AC power in order to correct the overload
condition and then press the overload reset switch on the front
panel. AC power will be restored immediately.
A
B