Petsafe PIF-300 Electric Pet Fence User Manual


 
20 1-800-732-2677
Re-synchronize the System
1. Remove the Receiver Collar from your pet.
2. Remove the battery from the Receiver Collar. Discharge all power by holding the correction level button
down until the LED is no longer illuminated.
3. At the transmitter, move the Boundary Switch from the low to the high position.
4. Slowly adjust the Boundary Control Dial up to 8, down to 1 and then back to the #4 position.
5. Standing within 5-10 feet of the Transmitter, reinsert the battery into the Receiver Collar.
6. Test the Boundary and verify operation by walking out into the Pet Area until your Receiver Collar
responds. (With the Transmitter set to 4, it should activate approximately 40-50 feet away).
Once you are confident that the system is working, reset the Transmitter controls to the original setting.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms,
conditions and notices contained herein. Usage of this Product implies acceptance of all such terms,
conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet
may not work with this Product. If you are unsure whether this is appropriate for your pet, please consult
your veterinarian or certified trainer.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or
provoke. Using this Product in a way that is not intended could result in violation of Federal, State or local
laws.
4. Limitation of Liability
In no event shall Radio Systems
®
Corporation be liable for any direct, indirect, punitive, incidental, special
or consequential damages, or any damages whatsoever arising out of or connected with the use or misuse
of this Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems
®
Corporation reserves the right to change the terms, conditions and notices under which
this Product is offered.