Filter
Top Products
52
4. Setting the Shot input: [SHOT INPUT]
Set the shot number for Shot distance measurement.
• The valid range of values for the shot number is from 1 to 99.
• This setting is enabled only when the shot number (Above 2.) has been
set to “4. INPUT”.
5. Selection of Laser plummet: [LD PLUM.]
Laser plumb ON/OFF is selected.
6. Selection of Tilting angle display: [TILT DISP.]
X and Y tilting values are displayed.
7. Selection for Minimum tilt display: [TILT DISP. UNIT]
COARSE or FINE:
8. Selection of Reflectorless range: [RANGE]
If you need the Normal or Long range.
9. Selection of Long range message: [MESSAGE]
If you need the long range message.
10. Selection of Long range setup:[SET UP]
If the above No.7 selection is required each
time or permanent.
11. Selection of primary MEAS setting: [PRIM.MEAS KEY]
Select whether the primary distance measurement is
MEAS SHOT or MEAS CONT or TRACK SHOT or TRACK CONT.
03 TIMES
1. OFF
2. ON
1. OFF
2. ON
1. COARSE
2. FINE
1. NORMAL
2. LONG
1. ON
2. OFF
1. EACH TIME
2. PERMANENT
1. MEAS SHOT
2 MEAS CONT
3. TRACK SHOT
4. TRACK CONT