Filter
Top Products
EN16
Assembly
1
2
Attaching the controller stand to the right or left side panel of this unit
Fasten the armrest with the attachment screws.
(On both the right and left sides)
Fasten the controller stand with the
attachment screws. (4 positions)
Use this screw … Attachment screws (M6 × 13)
× 4 pcs. (Black)
Insert the armrest into the unit.
“R” (right side) and “L” (left side) are indicated
at the bottom of the armrest.
Insert the armrest from the top aligning the ▲
marks on the side of the armrest.
Be careful to avoid pinching your fingers and air plugs.
Fasten the armrest with the attachment
screws. (One position for each side)
Use this screw … Attachment screws (M6 × 20)
× 2 pcs. (Silver)
Slide the armrest toward the back
while pushing it downward.
<When attaching on the right side panel>
Controller
Stand
<When attaching the right armrest>
Insert the armrest into the unit.
“R” (right side) and “L” (left side) are indicated
at the bottom of the armrest.
●❶
Fasten the armrest with the attachment
screws. (One position for each side)
Use this screw … Attachment screws (M6 × 20)
●❸
Slide the armrest toward the back
while pushing it downward.
●❷
● Tighten the 4 screws
lightly using your fingers.
(Make the screws level
with the holes.)
●
Align the 2 prongs of the
side panel with the holes
of the controller stand.
How to tighten the screws
How to tighten the screws
● Put an attachment screw
on the edge of the allen
key and tighten the screw
horizontally to the hole.
● Screw may be damaged
if you tighten the screw
inserted into the hole
crooked
ly using an allen key.
●
Tighten firmly with the allen key.
●
Screw may be damaged if
you tighten the screw inserted
into the hole crookedly using
an allen key.
Attachment screw
Hole
Allen key
Allen key
Align the ▲
marks.
Front
Back
●❶
●❷
●❸