15
English
6 Placing the controller
1
Placing the controller into the
controller stand.
2
Fasten the controller cord using
the clip.
• Fasten so the cable under the clip will not sag
too much with the backrest raised.
(Because there is a chance of your legs, etc.,
getting caught)
11
22
When the controller stand is attached on the left side
• Run the controller cord to the left.
1
Press the button on the controller to turn on the
power.
2
Press button on the controller and hold until
the legrest has risen far as it will go.
• Continue pressing until a “beep-beep-beep” sound is heard.
22
Legrest
3
Disconnect the controller cord.
• Hook is released by pressing on the tab on the fastening band with your ngers.
4
Move the controller cord under the legrest to the
left side.
5
Fasten the controller cord.
• Press down from the edge if it does not t in easily.
6
Insert the tip of the fastening band into the hole.
• The controller cord is fastened to the right side prior to leaving the
factory.
55
6
Cord-Holder Groove
Controller Cord
3
3
4
Controller Cord
Fasten to the right sideFastening band
Tab
View from front