Oregon S402022H0/S402022K0 Log Splitter User Manual


 
ALWAYS block the wheels to prevent movement of the log splitter while in operation.
KNOW how to stop the log splitter and disengage the controls before operating it.
NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in
serious injury or death.
NEVER straddle or step over the log splitter during operation.
NEVER reach or bend over the log splitter to pick up a log.
NEVER try to split two logs on top of each other.
NEVER try to cross split a log.
GENERAL REPAIR
NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
NEVER alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the
warranty.
NEVER tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer
and is within safety limits. Refer to the engine owner’s manual for your particular log splitter.
Page 4
OPERATION OF THE LOG SPLITTER
ONLY operate the log splitter from the operator zone as shown in the diagram. The operator has the safest and most
efcientaccesstothecontrolvalveandthebeaminthislocation.Operatingthelogsplitterinanotherlocationcanresult
in serious injury or death.
OPERATOR
ZONE
TOP VIEW
NEVER attempt to load the log splitter when the ram or wedge is in motion.
NEVER use your foot, a rope or any extension device to operate the control lever on the valve. Only use hand.
NEVER move the log splitter while the engine is running. Shut off the engine if you are leaving the log splitter, even for a
short period of time.
NEVER touchthemuferandotherhotareasoftheengineduringoperation.Waituntiltheenginecoolsdown.
ALWAYS be careful when moving or lifting the log splitter. Get assistance if it feels too heavy to move by yourself.